For manual and mechanical cleaning printing ink.Feature1 This product has a strong cleaning ability ink, non-toxic, harmless, non-flammable, store security. On the ink roller and mechanical without any adverse effects and damage. Cleaning printing press and with 2 clean compared to gasoline, cleaning time and cleaning effects are superior to gasoline, while consuming lower cost than gasoline.Cleaning roller divided into the following steps:

1 start printing presses to high speed, and then spray the ink roller on the amount of ink cleaner (washing water), separated by 15 seconds and then spray again. After 20 seconds until the machine running tight on ink scraping.

(2) after tightening the ink scraping the ink on the ink roller will continue to fade, this time; every 15 seconds in the ink roller suitable spray again until the ink on the ink roller is cleaned.

3. The ink roller add small amount of water, time will see a milky white liquid ink scraping, plus a small amount of water until no milky liquid so far.

4 Subject to the ink roller on the water completely dry off.5 Each spray ink cleaner is about 10 to 20 ml can.6 for the automatic cleaning of the printing press, should be required to join ink cleaner, based on actual usage set cleaning time.Features:

● This product is a combination of eco-solvent complexes formed, non-toxic, harmless, non-flammable, store security. On the ink roller and mechanical without any adverse effects and damage. Can effectively remove uv curable ink.How to use:

● Wash ago suggested that the main ink roller and the transfer roller separation.

● hang scraping the ink, but do not tighten the ink scraping.

● start the machine to a high speed, and then right to left on the ink roller spray two roundtrip uv ink cleaner is intended to enable cleaning agent combined with uv ink to complete the process of first colostrum. Separated by about 1 minute before spray a cleaning agent, which aims to enhance emulsification. Let the machine run for about one minute after the natural, the third spray two back and forth cleaning agent, in order to bring uv ink completely emulsified. After the machine run for about one minute after the natural tightening of ink scraping. (Note: Each spray dosage should not exceed 30 ml, this may cause the ink roller skidding. Meanwhile, the ink stick two should increase the amount of cleaning agent. Thicker ink should also increase the amount of local cleaning agent.)

● After tightening the ink scraping the ink on the ink roller will continue to fade, then every 30 seconds the ink roller back and forth on the proper spray two uv ink cleaning agent, (AIM: residual ink emulsification), the process for about 2 - 5 times. Until the ink roller is cleaned. (Note: If the ink scraper mouth is not usually a bad contact between the ink roller cleaning efficiency will affect the recommended ink scraper with artificial allow contact between the mouth and the ink stick is good or good replacement ink scraping).

● the ink roller add a little water. (Purpose: to be emulsified residual ink wash).At a time when the ink roller is thoroughly cleaned. But failed to shut down, continue to let the machine run until the water on the ink roller to dry completely before shutdown.

● In the case of a good printer, use cleaning products Baoli printing ink roller cleaning only 5 to 7 minutes.